Science and Engineering Project Create and Improve

 

 

 

 

Throughout the process of creating the hydroelectric device, I started by placing a cog onto the motor, the idea was to hot glue and secure small plastic spoons to be used as a wheel that turns by using the motion of the flowing water.  The way to attach the motor was to place a rectangular cut on the PVC pipe which will allow entry to the center of the pipe for the flowing water. Afterward, a plastic rectangular plate will be placed on the side of the opening to hot glue the motor into place; however, throughout the process of creating the wheel, I found that using pop stickle sticks are more effective and easier to place/ glue to the cog.

 

 

Leave a Reply

Your email address will not be published. Required fields are marked *